gsi misfire

Post queries regarding your Mk3 Cavalier's mechanical components (engine, transmission, turbochargers etc.) here
User avatar
planetc
Registered user
Posts: 6258
Joined: Wed Oct 20, 2010 9:59 pm
Location: Eating cake in Bexhill On Sea
Contact:

Re: gsi misfire

Post by planetc »

I was a tester in the 90s, and the easy way to remember what to test which way was that the k plate onwards had a cat test and earlier stuff was plain co and hydrocarbons. It may well be different now though as I haven't been a tester since 2001
"No the temperature gauge doesn't work........
we've driven 150 miles today........
the heater went cold last Thursday........
they check the level when it's serviced don't they?"
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

not sure if mine needs a cat or not.i hope not.lol
iv still not sorted the miss yet.
i tried a mass airflow meter from my pals and unplugged the lambda but still the same.was worse when i unplugged the lambda.
had my mate check the fuel preasure and he says its ok.

can it be the dizzy itself?
if the bumpers dont scuff then it aint low enuf.
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

iv been told that aswell as the distributor my car has an electronic dizzy somewhere.also my rad fan has been bridged and is running all the time.could this cause a misfire?
if the bumpers dont scuff then it aint low enuf.
User avatar
planetc
Registered user
Posts: 6258
Joined: Wed Oct 20, 2010 9:59 pm
Location: Eating cake in Bexhill On Sea
Contact:

Re: gsi misfire

Post by planetc »

No. You have substituted most of the likely candidates. Has your friend checked fuel pressure under load or just at idle? I would swap out the pressure regulator and injectors/rail to eliminate and following that you are probably looking at a mechanical fault like an air leak or sticky valve. Check all the pipework thoroughly for splits or cracks.
"No the temperature gauge doesn't work........
we've driven 150 miles today........
the heater went cold last Thursday........
they check the level when it's serviced don't they?"
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

if i unplug the hall effect plug on my dizzy while the engine is running what will happen?
if the bumpers dont scuff then it aint low enuf.
User avatar
planetc
Registered user
Posts: 6258
Joined: Wed Oct 20, 2010 9:59 pm
Location: Eating cake in Bexhill On Sea
Contact:

Re: gsi misfire

Post by planetc »

Cows will fart in the bath and moo very loud?
I'll give you time to think about this one yourself because you can probably figure it out without help, lol.
"No the temperature gauge doesn't work........
we've driven 150 miles today........
the heater went cold last Thursday........
they check the level when it's serviced don't they?"
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

just a quick update.
the misfire was down to the dizzy.got replacement and all is well.

got another question tho

what does this unit do.it seems to be power steering related
and where can i get a replacement from coz mine is leaking.
Attachments
2013-04-02 15.38.00.jpg
if the bumpers dont scuff then it aint low enuf.
User avatar
Gaz
Registered user
Posts: 6985
Joined: Sat Sep 22, 2007 1:05 pm
Location: Manchester

Re: gsi misfire

Post by Gaz »

4x4 bulb
Image
gsi pie
Registered user
Posts: 3769
Joined: Tue May 10, 2011 7:24 pm
Location: blackwood south wales

Re: gsi misfire

Post by gsi pie »

as above that runs the 4x4 system

do you have the 4x4 light on dash? or have you pulled fuse 19?
My valver brings all the boys to the yard, dam right its cammed and carbed, dam right it pops and farts, I would show you but the fuker won't start!
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

the 4x4 light is sometimes off and sometimes on.
when the light is on my windows dont work and when the light is off they do
if the bumpers dont scuff then it aint low enuf.
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

dropped the gsi off today for mot tomorrow so fingers crossed.
if the bumpers dont scuff then it aint low enuf.
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

got gsi back from mot test........FAIL.

needs nsf ball joint worn.
fuel leak at tank.(pipe)
front and rear registration plates honeycomb effect.
ns headlight aim too high.
nsf brake bipe insecure (not clipped in)

not bad at all considering it was stored in a garage for 6 years.
retest booked for friday then taxed and on the road.....yahey. :thumb :thumb :thumb
if the bumpers dont scuff then it aint low enuf.
User avatar
cavaliersri
Registered user
Posts: 87
Joined: Thu Feb 24, 2011 10:16 pm
Location: dundee

Re: gsi misfire

Post by cavaliersri »

hi folks.im back to nip your heads again.
my 4x4 light was staying on.i checked the fuse for power today and theres no power goin to it so i gave it a feed and now the 4x4 is working great.
the problem i have now is the light is on when ignition is on.when i start the car the light flashes continuously while the engine is on and when driving.
has anyone else experienced this.

although the car is driving in 4wd now the light flashing is doin my head in
if the bumpers dont scuff then it aint low enuf.
Post Reply