How have you all been then?
Everyone still driving cav's? I miss mine something terrible right now, so much so I am trying desperately hard not to go out and buy one!
Hello!
Moderator: Robsey
Re: Hello!
Evening Gary.
yup still driving my rusty old work horse.
It's still my daily driver
Yours (Fogs) will hopefully get sorted soon.
and when it is, it will outlast most others on the forum.
yup still driving my rusty old work horse.
It's still my daily driver
Yours (Fogs) will hopefully get sorted soon.
and when it is, it will outlast most others on the forum.
Re: Hello!
Not mine :)Robsey wrote:
Yours (Fogs) will hopefully get sorted soon.
and when it is, it will outlast most others on the forum.
....with a brew and my favourite biscuits.
Re: Hello!
I did say most, not all...btcctroy wrote:Not mine :)Robsey wrote:
Yours (Fogs) will hopefully get sorted soon.
and when it is, it will outlast most others on the forum.
there are a few real stunners on the forum...
Unlike mine, which is in very poor state and will be lucky to see a couple more years..
- Envoy CDX
- Club Admin
- Posts: 9676
- Joined: Sun Sep 23, 2007 3:51 pm
- Location: Jarrow, Newcastle Upon Tyne
Re: Hello!
Not if you get your fingers out and pick up the welder RobRobsey wrote:I did say most, not all...btcctroy wrote:Not mine :)Robsey wrote:
Yours (Fogs) will hopefully get sorted soon.
and when it is, it will outlast most others on the forum.
there are a few real stunners on the forum...
Unlike mine, which is in very poor state and will be lucky to see a couple more years..
You know you can do it.
Re: Hello!
Welding is the easier bit for me.
It is all the drilling out and unpicking of the spot welds,
and then the grinding smooth and prepping up that causes me to hesitate.
It is all the drilling out and unpicking of the spot welds,
and then the grinding smooth and prepping up that causes me to hesitate.
- Envoy CDX
- Club Admin
- Posts: 9676
- Joined: Sun Sep 23, 2007 3:51 pm
- Location: Jarrow, Newcastle Upon Tyne
Re: Hello!
That's the bit I enjoy!Robsey wrote:Welding is the easier bit for me.
It is all the drilling out and unpicking of the spot welds,
and then the grinding smooth and prepping up that causes me to hesitate.